Hope this helps, I spent years making brass masters and found out most tricks to get various finishes. Try both approaches to see the variation. Nostalgia aint what it used to be, but there was a time in my 1980s childhood when vinyl was all this scribe had to listen to. brass carriage running on horizontal rails so that the wheel cuts through the. Of course using a sharp compass point is OK when different appearance is needed. wheels (usually 1525 cm in diameter) of stainless steel or phosphor-bronze. Using a point to scribe the plank joint will leave the groove with a taper to a sharp point at the bottom of the groove, and also raise the sides on each side of the scribed line, but with a scraper this will leave a flat bottom to the scribed line and minimise raising an edge, which can be sanded away afterwards. If it is cutting correctly then brass swarf with result, no swarf and the force of the scriber may be bending the flat sheet of metal. Use against firmly backed brass sheet, with a steel rule to guide and space the groove lines.Įach stroke should be light, and repeated till the depth is achieved. The easiest way is to imagine a chisel drawn across the brass backwards in a scraping action.Ī micro bade suitable is plain scalpel blade, with the tip blunted by grinding, leaving the end and back of the blade width to act as the scraping chisel end. Blending decades of cycling expertise with industry knowledge. Passing on whether wood would be better(it is!!!), the way to scribe the lines on brass is to use a chisel.at least a micro chisel, not a point on a scriber. from 79.90 LIMITED STOCK CORE 50 Carbon Wheelset (1,434g) from 799.00 PRE-ORDER Pace (1,495g) from 36.00 DISCONTINUED MODELS Shop NOW ABOUT SCRIBE Scribe Cycling is home to a unique group of people.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |